Speed Engineering Front Brake Cooling Complete Set

A generally known problem: Your TTRS is fast! That in itself is not the problem, but the heat generated on the front axle by braking is. With this kit, we have found a solution to cool your brakes better.

Air duct inlet:

In order to transport the air to the brake ventilation outlet, a suitable inlet is essential. The TTRS 8J have an air duct in front of the wheel, through which the air is directed into the wheel arch. In order to prevent the air from swirling randomly in the wheel arch, we have developed an extension to the air duct which can be fitted with minimal effort, guides the air around the wheel and connects the air duct to our outlet via a 40 cm long hose (per side).

Air duct outlet:

Here too, the brake disk must be supplied with air as centrally as possible. The brake disk of the TTRS 8J has a large pot with existing openings on the anchor plate. We therefore refrained from developing a classic anchor plate. However, in order to make use of the turbine effect of the brake disc, we have developed a brake cooling system which is mounted on the wishbone and flows to the center of the disc regardless of the wheel position. It is simply attached using existing locking pins and without any permanent changes to the vehicle. A major advantage over a new anchor plate is that the system does not pivot, regardless of the wheel position. This means that the hose is not permanently under load and we have the option of transporting the air via a very short hose, thus reducing losses.

Included in the scope of delivery: