This product is suitable for the Golf 7 GTI and Seat Leon Cupra 5F.

For many vehicles, brake cooling is already recommended for medium loads, even off the racetrack. 

This not only improves braking performance, but can also drastically reduce wear on the friction partners. 

We use the channeling of the air flow to the center of the brake disc to utilize the turbine effect to cool the disc from the inside. In doing so, we direct the airflow at the disc at an angle in order to avoid scattering losses and make maximum efficient use of the available air volume. 

The lightweight construction in combination with powder-coated aluminum makes the component sufficiently strong and at the same time light and robust.


Included in the scope of delivery:

  • Anchor plates for the front axle 1x left 1x right with connection for 51 mm air hose
  • 6x washers
  • 10x cable ties

Air hose not included in the scope of delivery, this is available in our store, as are the matching hose clamps

Recommended hose length: 4 meters

The anchor plate fits plug & play and no additional fastening material is required. The original fixing points and screws can be reused. 

Your vehicle is not slow, that's a fact. However, this speed must be reduced as quickly as possible before the bend and this generates enormous heat. The ball joint of your control arm is extremely close to the hot brake disk and will be affected in the long term. This anchor plate therefore has an additional shield for the bearing, thereby increasing its durability. 


Article is suitable for

  • VW Golf MK7 GTI, GTI CS, GTI Performance
  • Seat Leon Cupra 5F

 

  • Volkswagen Golf Mk7 R
  • Volkswagen Golf Mk7 GTI
SKU SE-13218
Brand Speed Engineering

More From This Category